jsnosal - Tuesday, June 25, 2013 1:53 PM:
Is it possible to change the current life cycle state of part through AML? I'm looking primarily at Manufacture Parts. I have 7000 parts that I need to have set to approved. I have been trying to use the <current_state> id, but I haven't had any luck. Is there any special setting that I need to have in place? Thank you for your help. Its greatly appreciated.
newcomer - Wednesday, June 26, 2013 3:25 AM:
check this out:
http://amlstudio.codeplex.com/wikipage?title=Promote%20an%20Item&referringTitle=Documentation
jsnosal - Wednesday, June 26, 2013 8:39 AM:
Thank you so much Newcomer. You saved me a lot of time.
Josh
