Data integration with Solidworks via Direct PLM Connector

We have the same problem with the Direct PLM connector. We use Artec software -> Solidworks -> ARAS and saving the assemblies take a few hours usually with frequent crashes. Have you found the solution to this problem? If so, could you share it?

Well, after couple of unsuccessful attempts we involved Direct PLM vendor Focus PLM company and they cleaned the data and repeated the load process. It was not extremely fast, however, exercise was completed without crashes. So, my guess crashes happening due to incorrect drawings structure in Solidworks.  

Well, after couple of unsuccessful attempts we involved Direct PLM vendor Focus PLM company and they cleaned the data and repeated the load process. It was not extremely fast, however, exercise was completed without crashes. So, my guess crashes happening due to incorrect drawings structure in Solidworks.  

Thank you for the fast reply, we will check our drawings again.

hello, How to use  PLM connector to integrate with Solidworks, Thanks a lot.